You may also like.
BYD Shark 6 Front Bumper Lower Guard — Matte Black ABS Protection
The lower edge of your Shark 6's front bumper is the first thing to meet a gutter, a steep driveway or a stray stone — and it's an expensive panel to repaint. This matte black ABS lower guard takes the hits instead. Supplied as a two-piece set moulded to the Shark 6's factory contour, it bonds on with pre-installed industrial-grade 3M adhesive in about five minutes and gives the most vulnerable part of your front end a tough, factory-look shield.
Key Features
▪ Protects the most vulnerable panel — shields the lower edge of the front bumper from scratches, stone chips, kerb rash and minor knocks, the damage that normally means a respray
▪ High-grade ABS construction — rigid, impact-resistant and scratch-resistant, with the UV stability to hold its finish through Australian summers
▪ Matte black factory finish — reads as OEM rather than aftermarket, and pairs directly with the rest of the TIGER-X Shark 6 blackout range
▪ Two-piece design — left and right sections moulded to follow the factory bumper contour for a flush, gap-free line
▪ Pre-installed industrial-grade 3M adhesive — bonds securely to the bumper with no drilling, no cutting and no damage to the factory panel
▪ Roughly 5 minutes to fit — clean the surface, peel, position and press; no workshop visit required
Compatibility
▪ Suits: BYD Shark 6 2025-2026
What's in the Box
▪ 2 × Front bumper lower guard sections — matte black ABS, left and right
▪ Pre-installed industrial-grade 3M adhesive tape on both sections
Fitment Notes
▪ This guard is produced by thermoforming, so very slight variation at the edges can occur. This is normal for the process and does not affect fitment, strength or appearance once the guard is bonded to the bumper.
▪ For best adhesion, fit above 15°C on a clean, dry, wax-free surface and leave the vehicle unwashed for 24 hours afterwards so the 3M adhesive can fully cure.
Recently Viewed
Your browsing history.
